I think you may have introduced a new (nonfatal) bug. When I open more than one window in Arduino 1.05 Mac, I get an error message in the already-open window(s): “Invalid Drawer: trying to add a drawer that already exists: DFRobot”. Is there a testing missing or something? Thanks.
Hi, I can not open Arduino example program.
“Invalid Drawer: trying to add a drawer that already exists: DFRobot
”
IT is same bug as above. I feel it is fetal , is’t it?
Can somebody please tell me how to install this library on arduino?
I have downloaded the file but if I cut and paste it into the arduino library
it does not appear in ardublock
Thanks
Make sure that you replace the current Ardublock file in “tool” folder with this file. I am learning the hard way. thank you all for this development program.
Thankssssssssssssswsssswss
I think you may have introduced a new (nonfatal) bug. When I open more than one window in Arduino 1.05 Mac, I get an error message in the already-open window(s): “Invalid Drawer: trying to add a drawer that already exists: DFRobot”. Is there a testing missing or something? Thanks.
The bug is not fetal. It’s just a warning. There are two group of contributors sending in new items for DFRobot drawer with different drawerset.
Hi the array block is missing?¿
Hello, where can I get the keenlon.h ?
Thanks 🙂
You can download them here
Hi, I can not open Arduino example program.
“Invalid Drawer: trying to add a drawer that already exists: DFRobot
”
IT is same bug as above. I feel it is fetal , is’t it?
No worry about this one. It’s just a warning.
I cannot open a file saved with this version. (saves as .ino and also Arduino IDE cannot open the ino file). Where is my mistake ?
Could you post the files in our issue tracker?
Where the serial data available gone?
I can’t find “delay” blocks in control category. Is somebody have the same trouble ?
Hi, where can I get monMoteur9101112 fo DuinoEDU stepper motor? Thanks.
Help, any tutorial for SCoop?
Can somebody please tell me how to install this library on arduino?
I have downloaded the file but if I cut and paste it into the arduino library
it does not appear in ardublock
Thanks
Is anyone reading this site anymore?? there does not seem so be any support
Sorry to reply late. We have been busy with another project for a while and will be getting back to support Ardublock in the next week or two.
Their is mistake withe the ir remote
It give an error when i fix it manualy it ok
Try to fix it
Thanks
Make sure that you replace the current Ardublock file in “tool” folder with this file. I am learning the hard way. thank you all for this development program.